First, prepare LED wire lights, bobo balls, transparent plastic poles and batteries. Pump up the uninflated bobo first, then tie a dead knot at the end and set aside for later use. The LED wire light passes through the transparent plastic pole, the excess LED wire is wrapped around the well-beaten wave ball, and the battery is finally installed, and the light is lit on the wave ball installation is complete.
First, prepare LED wire lights, bobo balls, transparent plastic poles and batteries.
Installation steps:
Step 1: Pump the uninflated bobo ball inside with an air pump. When pumping, it is necessary to grip the air outlet of the ball and the place where the air pump is connected, otherwise it is easy to run. Tie a knot at the end and set aside for later.
Step 2: The LED light passes through the transparent plastic pole, and the wire connecting the LED light must be straightened as much as possible.
Step 3: Wrap excess LED light wire through the transparent pole around the newly inflated bobbin ball in such a way that the diameter of the ball forms a circle.
Step 4: Install the battery, if the light is on, it is in good condition, if the light is not on, the battery is not on, it is the problem of the light, and on the contrary, it is the problem of the battery.
Step 5: After the switch is turned on, the balloon emits colorful light, which is considered to be the completion of the installation of the wave ball.